Data Sheet

ManualsBrandsSIEMENS ManualsSiemens PLCs6NH7800-3CA00 PLC communication module

Data sheet 6NH7800-3CA00

Product type designation TIM 3V-IE Advanced

SINAUT ST7, TIM 3V-IE advanced communication module for

SIMATIC S7-300 with an RS232 interface for SINAUT

communication via a classic WAN and an RJ45 interface for SINAUT

communication via an IP-based network (WAN or LAN)

Transmission rate

Transfer rate

● for Industrial Ethernet

10...100Mbit/s

● acc. to RS 232

50...38400bit/s

Interfaces

Number of interfaces / acc. to Industrial Ethernet 1

Number of electrical connections

● for external data transmission / acc. to RS 232

● for power supply

Type of electrical connection

● of Industrial Ethernet interface

RJ45 port

● at interface 1 / for external data transmission

9 pin Sub-D-connector (RS232)

● for power supply

2-pole plugable terminal block

design of the removable storage / C-PLUG No

Supply voltage, current consumption, power loss

Type of voltage / of the supply voltage DC

Supply voltage 24V

6NH7800-3CA00 Subject to change without notice

Page 1/

Summary of content (5 pages)

PAGE 1
Data sheet Product type designation 6NH7800-3CA00 TIM 3V-IE Advanced SINAUT ST7, TIM 3V-IE advanced communication module for SIMATIC S7-300 with an RS232 interface for SINAUT communication via a classic WAN and an RJ45 interface for SINAUT communication via an IP-based network (WAN or LAN) Transmission rate Transfer rate ● for Industrial Ethernet 10 ... 100 Mbit/s ● acc. to RS 232 50 ... 38400 bit/s Interfaces Number of interfaces / acc.
PAGE 2
Supply voltage 20.4 ... 28.8 V Supply voltage / external / at DC / Rated value 24 V Supply voltage / external / at DC / rated value 20.4 ... 28.8 V Relative symmetrical tolerance / at DC ● at 5 V 5% Relative positive tolerance / at DC / at 24 V 5% Relative negative tolerance / at DC / at 24 V 5% Consumed current ● from backplane bus / at DC / at 24 V / maximum 0.2 A ● from external supply voltage / at DC / at 24 V / maximum 0.2 A Power loss [W] 5.
PAGE 3
● SINAUT ST7 via S7 communication Yes ● PG/OP communication Yes Performance data / multi-protocol mode Number of active connections / with multi-protocol mode 24 Performance data / telecontrol Suitability for use ● Node station Yes ● substation Yes ● TIM control center Yes ● Note RS232 and Industrial Ethernet can be operated in parallel Protocol / is supported ● DNP3 No ● SINAUT ST1 protocol Yes ● SINAUT ST7 protocol Yes Product function / data buffering if connection is aborted Yes; 32
PAGE 4
Hamming distance ● for SINAUT ST1 protocol 4 ● for SINAUT ST7 protocol 4 Product functions / management, configuration Configuration software ● required SINAUT ST7 ES ● for CPU configuring / required / SINAUT TD7 block library for CPU Yes ● for PG configuring / required / SINAUT ST7 configuration software for PG Yes Storage location / of TIM configuration data on the TIM Product functions / Security Suitability for operation / Virtual Private Network Yes Type of authentication / with Virtual P
PAGE 5
Security information Siemens provides products and solutions with industrial security functions that support the secure operation of plants, solutions, machines, equipment and/or networks. They are important components in a holistic industrial security concept. With this in mind, Siemens’ products and solutions undergo continuous development. Siemens recommends strongly that you regularly check for product updates.