User Manual

36
Smart Infrastructure
CE2N5324en
2019-06-27
For water temperatures above 90 °C and/or below 10 °C, mount the processor unit on the
wall (split mounting).
To fit the processor unit to the wall, remove it from the flow measuring section and undo the
screws of the adapter plate. The latter must then be secured to the wall so that the processor
unit can be replaced on the adapter plate, snapping into place.
NOTICE
On models with removable control wiring, you can disconnect and reconnect the wiring
during installation.
● Connect only paired parts (volume measuring section, processor unit) when
reconnecting.
● Note the correct pin assignment.
● Do not extend nor shorten the control wiring.
Maintenance
The meters are maintenance-free.
Observe all national calibration regulations.
Disposal
The device is considered an electronic device for disposal in accordance
with the European Guidelines and may not be disposed of as domestic
garbage.
● Dispose of the device through channels provided for this purpose.
● Comply with all local and currently applicable laws and regulations.
● Dispose of empty batteries in designated collection points.
Warranty service
The application-related technical data is only guaranteed together with the products
mentioned in this data sheet. Siemens rejects any and all warranties in the event that third-
party products are used.