Operation Manual

Table Of Contents
3
Athen / IM-MEA EN / A31008-M1801-A601-1-UZ19 / Athen_Kombi.fm / 30.10.2008
Setting up the telephone for use
Step 1: Connecting the base station
First connect the mains unit (230 V) to power
cord
1 and then connect the phone jack to phone
cord
2, as shown above. Place the cords in the cord
recesses. The two cords must be plugged in at all
times.
Only use the mains unit supplied.
If you ever purchase another phone cord from
a store, ensure that the phone conductors are
correctly connected: 3-4 connection of the tele-
phone conductors/EURO CTR37.
Step 2: Setting up the handset
Fitting the battery pack
Insert the plug into the socket as shown in the
enlarged view.
Insert the battery pack.
Place the cords in the cord routing.
Closing the battery cover
Insert the cover into the top end of the battery
compartment and press down until it clicks into
place.
Opening the battery cover
Place your fingernail between the cover and the
housing and pull the cover upwards.
12
Base station without answering machine
12
Base station with answering machine
Note:
The display is protected by a plastic film.
Please remove the protective film!
Place the battery leads in the cable guides so
that the battery cover cannot catch on the leads
and damage them when it is closed.
Use only the rechargeable battery pack rec-
ommended by Gigaset Communications GmbH *
(page 9), i.e. never use a conventional (non-
rechargeable) battery pack as this may cause sig-
nificant damage to health and property. For
example, the outer casing of the battery pack
could be destroyed or the battery pack could
explode. The phone could also malfunction or be
damaged as a result of using batteries that are not
of the recommended type.
Only use the battery charger supplied.
Only place the handset in the charging cradle
that is intended for it.
* Gigaset Communications GmbH is a trademark
licensee of Siemens AG.