Operation Manual

©
Siemens AG 2003, E:\Auftrag\Siemens\MobilePhones\A62 Artemis V2\en\Artemis_Main.fm
left page (2) of A62 Artemis en, A31008-H5890-A1-2-7619 (29.12.2004, 11:22)
Getting started
2
VAR Language: en; VAR issue date: 041111
Getting started
Using the SIM card/battery
Your phone's display is delivered with a
protective film. Remove this film before get-
ting started. The service provider supplies
you with a SIM card on which all the im-
portant data for your account is stored. If
the SIM card is credit card-sized, snap out
the smaller segment and trim any rough
edges.
Remove the battery cover upwards
1
.
Insert SIM card
2
and push it fully into
the locating slot (make sure the angled
corner is in the correct position
3
). Then
push the retaining catch over the top of
the SIM card
4
.
Insert the battery sideways into the
phone
5
, then press downwards
6
until it engages.
To remove, press the retaining tab
7
then lift the battery out.
Insert the battery cover by the tabs at the
bottom
8
, then press downwards
9
,
until it engages.
Always switch off phone before removing
the battery!
Only 3 V SIM cards are supported. Please
contact your service provider if you have
an older card.
Charging the battery
The battery is not supplied fully charged.
Plug the charger cable into the bottom of
the phone, plug the power supply unit
into a mains power socket and charge for
at least two hours.
1
2
4
3
6
7
5
8
9