User Manual

74/101
Building Technologies Operating Instructions for ACS Operating and ACS Service CE1U5640en
HVAC Products 3 Applications Dec. 1, 2005
• Copying files
3.7 Parameter settings
3.7.1 Introduction to the "Parameter settings" application
This application enables the settings of the connected devices to be downloaded,
uploaded or compared.
The settings can be
• stored as a parameter set
• compared with a stored parameter set
• compared with the standard parameter set
• overwritten with a stored parameter set
• overwritten with the standard parameter set
The parameter sets can be edited either online or offline. The data points of the
parameter set can be selected individually. The transmission result of uploading,
downloading or comparing is displayed online.
The parameter set can be printed out or exported as an ASCII file.
For more information, refer to the following chapters:
• Processes in the "Parameter settings" application.
3.7.2 Processes in the "Parameter settings" application
The following processes are described in this chapter:
• Creating a new parameter set
• Adapting the parameter set
• Uploading the parameter set
• Downloading a parameter set
• Comparing parameter sets
• Printing in the parameter settings
• External editing of the parameter set
3.7.3 Creating a new parameter set
In addition to the existing standard parameter sets, you can create your own user-
defined parameter sets:
• Standard parameter set: Parameter set in which all parameters are set to the default
values as supplied
• User-defined parameter set: Parameter set created by yourself:
• To repeatedly load frequently used parameter settings to devices without having
to change each parameter over and over again
• To store a status of a device on the PC so that the particular status can be
reestablished at a later point in time
Procedure:
A. To create a new parameter set, select from the "Parameter settings" application in
the left window the device for which you want to have the new parameter set filed.
Position the onscreen pointer in the right window of the application and press the
right mouse button. A menu is opened. Select New and then Parameter set....
New parameter set