Installation Instructions

TERMINAL
BLOCK
TO NEXT DETECTOR OR EOL DEVICE SEE NOTE
ZONE WIRES FROM SIEMENS INDUSTRY, INC. COMPATIBLE CONTROL PANEL (SEE TABLE 1)
OPTIONAL REMOTE ALARM INDICATOR MODEL RL-30, RL-40, RLI-1, OR RLI-2, IF SUPPORTED BY ZONE
OPTIONAL REMOTE ALARM INDICATOR MODEL RL-30, RL-40, RLI-1, OR RLI-2, IF SUPPORTED BY ZONE
Model AD-3I
DI-B3
or
DI-B3H
DI-B3
or
DI-B3H
Model AD-3I
Figure 6
Typical Connections for System 3, CP-2ER, System PXL, System SXL-EX
System SXL, MXL/MXL-IQ Control Panel (CZM-1, CZM-1B6, CZM-4)
NOTE: EOL device must be compatible with system initiating circuit. Observe proper polarity where applicable.
10
CAUTION: 1. See Table 3 for maximum
number of air duct detectors per circuit.
2. If remote lamps are used, the
relay board option cannot be used.
3. Remote lamps may not be
used with the MXL/MXL-IQ Control Panel (CZM-1, CZM-1B6, CZM-4) and SXL.
4. When a remote relay is used
to control a critical system function, the relay and its associated detector and optional module(s) must be the ONLY devices on the initiating circuit.