User Manual

2/16
Building Technologies Division CC1N7118en
19.05.2016
Warning notes
To avoid injury to persons, damage to property or the environment, the following
warning notes must be observed!
Do not open, interfere with or modify the unit!
 All activities (mounting, installation and service work, etc.) must be performed by
qualified staff
 Before making any wiring changes in the connection area, completely isolate the
plant from mains supply (all-polar disconnection). Ensure that the plant cannot be
inadvertently switched on again and that it is indeed dead. If not observed, there is
a risk of electric shock hazard
 Ensure protection against electric shock hazard by providing adequate protection
for the burner control’s connection terminals. If not observed, there will be a risk of
electric shock
 Each time work has been carried out (mounting, installation, service work, etc.),
check to ensure that wiring is in an orderly state and make the safety checks as
indicated in Commissioning notes above. If this is not observed, there is a risk of
loss of safety functions and a risk of electric shock.
 Press the lockout reset button / operating button only manually (applying a force of
no more than 10 N), without using any tools or pointed objects. If this is not
observed, there is a risk of loss of safety functions and a risk of electric shock.
 Fall or shock can adversely affect the safety functions. Such units must not be put
into operation, even if they do not exhibit any damage. If this is not observed, there
is a risk of loss of safety functions and a risk of electric shock.
Attention!
Earth the burner in compliance with the relevant regulations; earthing the boiler
alone does not suffice!
Mounting notes
Ensure that the relevant national safety regulations are complied with.