Operation Manual

13
AL180/AL185/AL280/AL285 / MEA EN / A31008-M2003-R101-1-UZ19 / main.fm / 31.10.2008
Specifications
Recommended batteries
Technology: Nickel-metal-hydride (NiMH)
Size: AAA (Micro, HR03)
Voltage: 1.2 V
Capacity: 400–800 mAh
We recommend the following types of battery:
◆ GP 550/700 mAh
◆ Yuasa Phone 700/800 mAh
◆ Peacebay 550/650 mAh
(Valid at the time of going to press)
The handset is supplied with recommended batter-
ies.
Base station power consumption
General specifications
Questions and answers
If you have any queries about the use of your tele-
phone, visit our website at
www.gigaset.com/customercare
for 24-hour support. The table below contains a list
of common problems and possible solutions.
Authorisation
This device is intended for connection to analogue
networks outside the EEA (with the exception of
Switzerland) depending on national type approval.
Country-specific requirements have been taken
in
to consideration.
We, Gigaset Communications GmbH, declare that
th
is device meets the essential requirements and
other relevant regulations laid down in Directive
1999/5/CE.
A copy of the 1999/5/EC Declaration of Conformity
is a
vailable at this Internet address:
www.gigaset.com/docs.
In standby mode
– Handset in base station
– Handset outside base station
approx. 1.3 W
approx. 1.3 W
During a call approx. 1.5 W
DECT standard is supported
GAP standard is supported
Range up to 300 m outdoors
up to 50 m indoors
Base station power supply 230 V ~/50 Hz
Environmental conditions
in operation
+5 °C to +45 °C, 20% to
75% elative humidity
Problem Cause Solution
Nothing
appears in
the display.
The handset is not
switched on.
The batteries are
fl
at.
Press the end call
ke
y
a for approx.
5 seconds or place
the handset in the
base station.
Charge or replace the
batt
eries.
No wireless
co
nnection
to the base
st
ation,
Base flashes
in th
e display.
The handset is
outsid
e the range
of the base sta-
tion.
The handset is not
r
egistered.
The base station is
n
ot turned on.
Move the handset
closer t
o the base
station.
Register the handset
¢ p. 10.
Check the mains con-
nector on the base
st
ation
¢ p. 3.
You cannot
hear a ringer/
dialling tone
from the fixed
line network.
The phone cord
supp
lied has not
been used or has
been replaced by
a new cord with
the wrong jack
connections.
Please always use the
ph
one cord supplied
or ensure that the
pin connections are
corr
ect when purchas-
ing from a retailer:
3-4 assignment of
t
elephone leads/
EURO CTR37.
Error tone
sounds af
ter
system PIN
pr
ompt.
PIN forgotten.
The system PIN
y
ou have entered
is incorrect.
Reset the system PIN
to the default 0000
¢ p. 11.
All handsets are
de-registered. All
se
ttings are reset.
All lists are deleted.
Problem Cause Solution