Installation Instructions

en 8 / 8 2018-04-09 A6V101022113_----_b A5W00027977 A Siemens Building Technologies
Set up web server on the remote access portal
• No router settings are required to operate via the portal.
1. Enter the portal web address from the package insert in the web
browser on the PC/laptop.
2. Select language.
3. Create new account ("Sign up") using a personal e-mail address
and activation code (provided on the package insert).
4. Log in using the password received by mail.
After initial log in, the user is requested to change the password.
5. Fill out plant information and activate the device.
6. Click the plant link.
7. Using an existing account, the device is activated after log in
under "Administration".
8. Navigation: Primary navigation (horizontal menu), secondary
navigation (vertical menu) and path navigation (levels below the
primary menu).
9. Return navigation: Click the symbol "Upward" or navigate
via path or primary navigation.
Change local administrator password
• The local administrator password for the web server must be
changed to prevent unauthorized access to the web server.
10. Under primary navigation, select "User accounts".
11. Click the red pencil .
12. Create new password.
13. Click [OK].
Create device list
• The Web server monitors only the bus devices listed in the device
list.
• The first device can be added to the device list using quick
commissioning and the device website is generated.
14. Long press > 6 sec. of the service button (7)
- Quick commissioning LED (5) flashes green
- Connected device 0.1 or. 1 is added to the device list
- Device website is generated
- The state is indicated using the quick commissioning LED (5)
for 10 sec.:
Green: Device 0.1 or 1 is connected.
Red: Device 0.1 or 1 is not connected.
- Quick commissioning LED (5) off. The state can be indicated
again with a short press of the service button (7).
Skip steps 15 – 20 if quick commissioning was successful and no
additional devices need to be connected.
• Add devices to the device list.
15. Select "Device web pages" from primary navigation. The device
list opens and the Web server appears in the device list.
16. Add new bus device: Click [Add].
17. Enter LPB address (for LPB only). The first bus device is
addressed with 0.1 (segment 0, device 1) as the default.
Finish with [OK].
• The Web server searches for the corresponding bus device.
It appears in the device list.
18. Add other bus devices: Repeat steps 16 and 17.
19. Check the box for all devices in the device list .
20. Click [Generate] and wait until the message "Process finished"
appears. This may take a few minutes.
Result: In the device list, the Web server and the bus devices display
the status "Generated".
Web server settings
• Edit settings: Click the red pencil symbol .
21. Select "Home" from primary navigation:
Home > 0.5 OCI670
22. …> Time of day/date: Time of day/date
23. …> Settings > Web server: Language
24. …> Settings > Time of day/date:
Summer time start, Winter time start
25. …> Settings > Communication > :
Device number, Clock time source
• Additional information on e-mail transmission of faults, system
report, "Energy Indicator" and trend is available in the
commissioning guide A6V101022140_en--_b.
Final check on web server
• ON LED (1) must be green or orange.
• Fault LED (4) should be unlit.