User Manual

ManualsBrandsSiemens ManualsFire - Panels & SystemsAlgoRex EP7F-/2.2 Release Notes for Service Technicians

Building Technologies

Fire Safety & Security Products

Titanus 3000

Air sampling smoke detection

system

High sensitive

z Early fire detection for the protection of rooms and equipment with immunity to

deceptive phenomena even in difficult areas with powerful interference

z Adaptable, displayed sensitivities using DS11 smoke detectors

z Optimum detection reliability using algorithms

z The system can be ideally adapted to the conditions at the place of installation

through the choice of a suitable smoke detector and the corresponding stored

sets of parameters

z Optimum choice of location for operation and maintenance

z Monitoring and rapid fire location through the display of the analog value and

the three danger levels at the device and on the parallel display

z Monitored air flow in the tube system and at the air sampling points

z Easy to service

Summary of content (8 pages)

PAGE 1
Titanus 3000 Air sampling smoke detection system High sensitive z Early fire detection for the protection of rooms and equipment with immunity to deceptive phenomena even in difficult areas with powerful interference z Adaptable, displayed sensitivities using DS11 smoke detectors z Optimum detection reliability using algorithms z The system can be ideally adapted to the conditions at the place of installation z z z z through the choice of a suitable smoke detector and the corresponding stored sets of par
PAGE 2
Application Titanus 3000 can be used wherever high sensitivity is required and where point-type detectors are unsuitable due to inaccessibility or room height, where they would spoil the decor or as protection against tampering.
PAGE 3
Equipment monitoring Tube system Titanus 3000 3 Building Technologies Fire Safety & Security Products
PAGE 4
Operating principle Titanus 3000 takes continuous air samples from the area monitored via a tube system with defined air sampling points (room, cabinet, etc.) and passes them on to a smoke detector. The air flows to the device below and out into the open air. It could also, e.g. with differing air pressure, be carried back by tube to the monitored area. The smoke concentration is immediately displayed on a 10-step bar graph as well as being indicated by three flashing LEDs.
PAGE 5
Sensitivities Different sensitivities can be selected and set according to the type of application. By selecting a suitable type of smoke detector and adjusting its various parameter sets, Titanus 3000 can be optimally adapted to its function. In addition, a remote controlled switchover between two different parameters is possible (day/night, manned/unmanned switchover).
PAGE 6
Tube systems I-tube system U-tube system Double U-tube system Commissioning and maintenance Commissioning and maintenance require little work. Automatic detector recognition, loading of the set parameters, setting and calibration of the self-learning air flow sensor are all microprocessor-controlled and carried out at the press of a button. The Titanus 3000 gives an application error warning if the device has been incorrectly used.
PAGE 7
A comprehensive range of accessories is available for the engineering of an entire fire detection system: Air filters, return air element, tube system components, ceiling feedthrough tubes, mounting plates, etc. Parallel indicators are available in housings for wall-mounting or as 19" modules. All functions indicated on the front panel are also indicated by the separate display.
PAGE 8
Technical data Supply voltage (Ue) 21… 30 VDC 24 VDC 200 mA ±12 % max. 320 mA – Rated voltage Quiescent current (at 24 VDC) Alarm current (at 24 VDC) Monitoring of air flow in tube system – for fracture – for blockage Sensitivities – Main display – with detector DO1161A (5308000001) – with detector DO1153A (5000500001) – with detector DO1151A (4930150001) Display on housing front panel Up to tube end 50 % or single hole 0.01 %/m (0.003 %/ft) 0.03 %/m (0.009 %/ft) 0.15 %/m (0.