User Manual

ManualsBrandsSiemens ManualsFire - Panels & SystemsAlgoRex EP7F-/2.2 Release Notes for Service Technicians

Building Technologies

Fire Safety & Security Products

Titanus SuperSens

Air sampling smoke detection

system

Highest sensitivity

z Very high smoke detection response sensitivity (0.0025 %/m)

z 4 adjustable values for detector sensitivity (alarm values)

– 0.2 %/m

– 0.1 %/m

– 0.05 %/m

– 0.025 %/m

z 3 levels of alarm (info, pre and main alarm)

z Monitoring of the air flow in the tube system and signalization of tube rupture

or sampling point blockage

z Early fire detection for the protection of rooms and equipment of high value

and where extremely high sensitivity is requested

z Design of long pipe systems possible

Summary of content (4 pages)

PAGE 1
Titanus SuperSens Air sampling smoke detection system Highest sensitivity z Very high smoke detection response sensitivity (0.0025 %/m) z 4 adjustable values for detector sensitivity (alarm values) z z z z – 0.2 %/m – 0.1 %/m – 0.05 %/m – 0.
PAGE 2
Application Titanus SuperSens can be used whenever high sensitive smoke detection is required and where point-type detectors are unsuitable due to inaccessibility, room height, atmospheric conditions or special ventilation situations (high air speeds, etc.). Scope of application Typical applications for the Titanus SuperSens are: – Production plants (clean rooms) in semiconductor industry – EDP rooms – High warehouses and halls – etc.
PAGE 3
Installation Titanus SuperSens is mounted on walls or cabinets. By reversing the device the connection socket can be positioned upwards or downwards. By removing the device cover, full access is provided to the programming modules without any influence on the air flow monitoring. Commissioning and maintenance Easy commissioning is provided due to microprocessor controlled calibration of the air flow sensor and the easy set up of the sensitivity.
PAGE 4
Technical data Supply voltage (Ue) – Rated voltage Quiescent current (at 24 VDC) Alarm current (at 24 VDC) Monitoring of air flow in tube system – for fracture – for blockage Response sensitivities (first level of bar graph indication) – Level I – Level II – Level III – Level IV Display on housing front panel 14… 30 VDC 24 VDC 245 mA max. 320 mA Up to tube end 50 % or single hole 0.02 %/m 0.01 %/m 0.005 %/m 0.