User Manual

ManualsBrandsSiemens ManualsFire - Panels & SystemsAlgoRex EP7F-/2.2 Release Notes for Service Technicians

Building Technologies

Fire Safety & Security Products

DZ1193, FDUM291, FDUM292

AlgoRex

Detector exchanger and tester,

Telescope rods

z For the simple insertion, exchanging and testing of DS11 smoke detectors

z Optoelectronic detector testing enables environmentally friendly testing with-

out test gas

z Full testing of the optical sampling chamber

z Suitable for commissioning and maintenance work

z The telescope rod FDUM291 with continuous length adjustment up to approx.

5.5 m room height and the telescope rod FDUM292 with continuous length ad-

justment up to approx. 8 m room height serve as extension

Summary of content (4 pages)

PAGE 1
DZ1193, FDUM291, FDUM292 AlgoRex Detector exchanger and tester, Telescope rods z For the simple insertion, exchanging and testing of DS11 smoke detectors z Optoelectronic detector testing enables environmentally friendly testing with- out test gas z Full testing of the optical sampling chamber z Suitable for commissioning and maintenance work z The telescope rod FDUM291 with continuous length adjustment up to approx. 5.
PAGE 2
Detector exchanger and tester DZ1193 Application – The DZ1193 detector exchanger and tester is a device for the simple insertion, exchanging and testing of all DS11 smoke detectors. – The DS11 heat detector can be inserted and removed, but not tested with this device. Design – The DZ1193 has a combined pluck and test head attached to a short, flexible extension rod.
PAGE 3
Telescope rods FDUM291 and FDUM292 Characteristics – yellow plastic tubes in light and robust execution (non-conductive material) – plastic sockets and slide bearings provide for easy sliding of the tubes – quick spring-type locking mechanisms and continuous length adjustment – The tubes can be extended to their maximum length and are protected against further extension by a stop bolt. – Further extension of the telescope rods is not possible.
PAGE 4
Technical data Forbidden in explosion-hazard areas! Operating voltage – Alkaline battery Operating current – Standby (detector inserted) – Test procedure Number of tests per battery – in test mode (10 s) Operating temperature – transient Storage temperature – with battery Humidity 9 VDC Type IEC 6 LF 22 / capacity 500 mAh ≤4 mA ≤16 mA ≥3000 -25… +40 °C -30… +50 °C -30… +75 °C -25… +60 °C ≤95 % rel.