User Manual

ManualsBrandsSiemens ManualsFire - Panels & SystemsAlgoRex EP7F-/2.2 Release Notes for Service Technicians

Building Technologies

Control Products and Systems

DC1154 / DC1154-AA / DC1156-AA /

DC1157-AA

AlgoRex

Input / Output modules

Interactive

l DC1150 Series

– Thanks to its robust construction, the line modules can be used in both dry and

dusty / wet areas

– Housing for surface mounting with M20 cable entries

l DC1150-AA Series

– For use in dry areas

– Can be mounted in a row with standard guides TS35

l Two-wire installation

l No additional supply required

l Equipped with isolating function

Summary of content (8 pages)

PAGE 1
DC1154 / DC1154-AA / DC1156-AA / DC1157-AA AlgoRex Input / Output modules Interactive l l l l l DC1150 Series – Thanks to its robust construction, the line modules can be used in both dry and dusty / wet areas – Housing for surface mounting with M20 cable entries DC1150-AA Series – For use in dry areas – Can be mounted in a row with standard guides TS35 Two-wire installation No additional supply required Equipped with isolating function Building Technologies Control Products and Systems
PAGE 2
In-/output modules DC1154, DC1154-AA Function – The address is assigned during commissioning via the key integrated in the module and confirmed by the flashing of the red LED. – DC1154: With closed housing, the key and the LED are not visible – DC1154-AA: The LED lights through the transparent cover – The key is provided to release a danger signal during normal operation (performance check) – Messages can be carried out with volt-free make or break contacts.
PAGE 3
Output module DC1156-AA Function – The address is assigned during commissioning via the key integrated in the module and confirmed by the flashing of the red LED. – The LED lights through the transparent cover. Application – Control output with 3 volt-free relay contacts provides decentralized activation of fire doors, ventilators, air conditioning, lift controls etc.
PAGE 4
Input module DC1157-AA Function – The address is assigned during commissioning via the key integrated in the module and confirmed by the flashing of the red LED. – The LED lights through the transparent cover. – The acknowledgement lines are monitored by end resistors for interruption and the corresponding control unit configuration also for short-circuit. Application – Enables the connection of three independent volt-free make or break contacts for the acknowledgement of technical statuses (e.g.
PAGE 5
Installation DC1154 – The housing with cover DCA1191 and the terminal base DCB1154A are required for installation. – The housing has six M20 threaded cable entries to feed in the cable. – It can be used in dry, dusty and wet areas. – The electronics unit is only inserted after the wiring check shortly before commissioning. DC1154-AA, DC1156-AA, DC1157-AA – Mount in series on standard rail TS35 with mounting plate DCZ1190-AA possible.
PAGE 6
Dimensions DC115x-AA and DCZ1190-AA DCA1191 97 22 65 88 11.5 111 71.
PAGE 7
Building Technologies Fire Safety
PAGE 8
Details for ordering Type DCA1191 DCA1154A DCB1154A DBZ1190-AA – DC1154-AA DC1156-AA DC1157-AA DCZ1190-AA – DC1154 DC115x-AA Issued by Siemens Switzerland Ltd Building Technologies Division International Headquarters Gubelstrasse 22 CH-6301 Zug Tel. +41 41 724 24 24 www.siemens.com/buildingtechnologies Document no.