Installation Instructions

ManualsBrandsSiemens ManualsBuilding automationCE Compliant Dual Duct Controller Two Air Velocity Sensors Electronic Output Installation Instructions

Document No. 540-569

July 15, 2009

Smoke Control

Listed Dual Duct Controller with One Air Velocity

Sensor — Electronic Output

24 V-AC

DO 1 DO 2 DO 3 DO 4 DO 5

NO C NO C NO C NO C NO C

DO 6 DI 3 DI 2 FLN

TRUNK

NO C

POWER

TRUNK

TERMINATIONS

FLN TRUNK

TERMINATIONS

MOUNTING

HOLE

(2)

CONTROLLER

BOARD

COVER

MOUNTING

RAIL

DO LEDS

INPUT/OUTPUT TERMINATIONS

TRANSMIT LED

RECEIVE LED

AI 3

TX RX + - S

BST RTS

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

TEC0200-SR1

BST LED ROOM TEMPERATURE

SENSOR/MMI PORT

AIR VELOCITY

SENSOR PORTS

Figure 1. Smoke Control Listed Dual Duct Controller with One Air Velocity Sensor — Electronic Output.

Control Applications

2035, 2036, 2064, 2065 and 2066

Product Description

The Term

inal Equipment Controller (TEC) provides

high per

formance DDC of pressure-independent,

variab

le-air-volume zone-level routines. The TEC

can ope

rate stand-alone or can be networked

to perf

orm complex HVAC control functions.

The TEC

canalsobeusedaspartofaSiemens

engine

ered smoke control system. The TEC are

used t

o initiate the operations of dampers and fans

but th

e smoke control strategy will be initiated from

any of

the APOGEE ﬁeld panels and not by the TEC.

These

instructions explain how to ﬁeld install

or rep

lace a Smoke Control Listed Dual Duct

Cont

roller with One Air Velocity Sensor — Electronic

Outp

ut with or without an Autozero Module.

Product Numbers

540-106

Smoke Control Listed Dual Duct Controller

with One Air Velocity Sensor — Electronic

Output

540-107K

Smoke Control Listed Dual Duct Controller

with One Air Velocity Sensor — Electronic

Output with AutoZero module.

540-808K

Smoke Control Listed Dual Duct Controller

– One Air Velocity Sensor — Electronic

Output for Trane

540-809K

Smoke C

ontrol Listed Dual Duct Controller

–OneAi

r Velocity Sensor — Electronic

Output

with Autozero Module for Trane

Shipping carton includes a controller assembly,

mounting rail, Autozero Module with bracket

(540-107K only), and two self-tapping screws.

CAUTI

ON:

Keep the unit in its static-proof bag until

installation.

tem Number: 540-569, Rev. CA

age 1 of 12

Summary of content (12 pages)

PAGE 1
Installation Instructions Document No.
PAGE 2
Document No. 540-569 Installation Instructions July 15, 2009 Warning/Caution Notations Accessories 540-658P25 WARNING: Low cost temporary temperature sensor that enables space control if the permanent room or duct sensor is not installed. Personal injury/loss of life may occur if you do not follow the procedures as speciﬁed. CAUTION: Parts for Smoke Control Compliance Equipment damage or loss of data may occur if you do not follow the procedures as speciﬁed.
PAGE 3
Document No. 540-569 Installation Instructions July 15, 2009 Transformer Installation for Smoke Control Applications CAUTION: Do not ground the shield. P/N 5041MWCB and 10041MWCB 5. Connect the point wiring (see Wiring Diagrams). 1. Mount the transformer to a facility installed UL Listed junction box (2x4 or 4x4). Mount the integral conduit nipple through the knock-out on the junction box. 2. Connect the secondary wires to the TEC using UL Listed CL2 or equivalent cables. 6.
PAGE 4
Document No. 540-569 Installation Instructions July 15, 2009 • Transformer P/N 10041BCWB: maximum 6VA per DO/ maximum 36 VA total. CE Compliance • Transformer P/N AM-2483-OA: maximum 6VA per DO/ maximum 16 VA total. If CE compliance is required, a ferrite ﬁlter must be placed approximately 1 cm from the end of the cable being shielded (RTS cable[ and the point wiring for AI3]) (Figure 4). 3. The room temperature sensor (RTS) is installed in the same room as the TEC. 4.
PAGE 5
Document No. 540-569 Installation Instructions July 15, 2009 AIR VELOCITY SENSOR PORTS CONTROLLER LO HI E 24 V -AC C H C H DO 1 NO C DO 2 D O 1 2 NO C NO 3 DO 4 DO 3 4 C 5 6 NO C NO 5 DO 6 DI 7 8 C 9 10 NO C AI 3 DI 2 11 12 3 1 2 13 14 3 4 15 16 5 6 7 8 9 10 11 12 13 14 15 16 AUTOZERO MODULE TX FLN TRU + - NK S B ST RX + - RTS S TEC0205-SR2 LO Figure 5.
PAGE 6
Document No. 540-569 Installation Instructions July 15, 2009 Wiring Diagrams CAUTION: The controller’s DOs control 24 Vac loads only. The maximum rating is 6 VA for each DO.
PAGE 7
Document No. 540-569 Installation Instructions July 15, 2009 24 V-AC C H DO 1 DO 2 DO 3 DO 4 DO 5 DO 6 DI 3 DI 2 NO C NO C NO C NO C NO C NO C AI 3 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 FLN TRUNK TX RX + - S BST RTS 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 TEC2035BWD-SR1 ROOM TEMPERATURE SENSOR Figure 9.
PAGE 8
Document No. 540-569 Installation Instructions July 15, 2009 24 V-AC C H FLN TRUNK TX RX + - S BST DO 1 DO 2 DO 3 DO 4 DO 5 DO 6 DI 3 DI 2 NO C NO C NO C NO C NO C NO C AI 3 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 RTS 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 TEC2035BWD-SR1 ROOM TEMPERATURE SENSOR Figure 11.
PAGE 9
Document No. 540-569 Installation Instructions July 15, 2009 24 V-AC C H DO 1 DO 2 DO 3 DO 4 DO 5 DO 6 DI 3 DI 2 NO C NO C NO C NO C NO C NO C AI 3 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 FLN TRUNK TX RX + - S BST RTS 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 ROOM TEMPERATURE SENSOR WALL SWITCH (OPTIONAL); OR, SPARE DI (DRY CONTACT CLOSURE ONLY) Y1 G Y2 TEC2064BWD-SR1 CW CCW COMMON Figure 13.
PAGE 10
Document No.
PAGE 11
Document No. 540-569 Installation Instructions July 15, 2009 24 V-AC C H DO 1 DO 2 DO 3 DO 4 DO 5 DO 6 DI 3 DI 2 NO C NO C NO C NO C NO C NO C AI 3 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 FLN TRUNK TX RX + - S BST RTS 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 TEC2066AWD-SR1 ROOM TEMPERATURE SENSOR Figure 17.
PAGE 12
Document No. 540-569 Installation Instructions July 15, 2009 Information in this document is based on speciﬁcations believed correct at the time of publication. The right is reserved to make changes as design improvements are introduced. Product or company names mentioned herein may be the trademarks of their respective owners. © 2009 Siemens Building Technologies, Inc. Siemens Building Technologies, Inc. 1000 Deerﬁeld Parkway Buffalo Grove, IL 60089-4513 U.S.A. Your feedback is important to us.