Installation Instructions

Document No. 540-570
Installation Instructions
July 15, 200 9
Product Numbers
540-103K
Smoke Control Listed Constant
Volume Controller — Electronic
Output
540-104K
Smoke Control Listed Constant
Volume Controller — Electronic
Output with Autozero Module
540-103CK Smoke Control Listed Constant
Volume Controller — Electronic
Output with Secure Mode
540-104CK Smoke Control Listed Constant
Volume Controller — Electronic
Output with Autozero Module and
Secure Mode
CAUTION:
Keep the unit in its static-proof bag until
installation.
Accessories
540-628P25
(pack of 25)
Low cost temporary temperature
sensor that enables space c ontrol if
the permanent room or duct sensor is
not installed.
Parts for Smoke Control Compliance
540-155K
Smoke Contro l Listed Small
Equipment Controller Enclosure
550-002K
Smoke Control Listed Large
Equipment Controller Enclosure
ZBX-XXXX
a
Smoke Control Listed Large
Equipment Controller Enclosure
5041MWCB UL Listed Class 2 transformer
with 120/240/277/480 Vac
50/60 HZ 0.4 A primary w/ hub
and 24Vac 50VA secondary w/
hub and circuit breaker
10041MWCB UL Listed Class 2 transformer
with 120/240/277/480 Vac
50/60 HZ 0.5 A primary w/ hub
and 24Vac 96VA secondary w/
hub and circuit breaker
KELE AM-2483-OA UL Listed Class 2 Transformer
with primary 120V 60 HZ 0.2A
secondary 24 Vac 30 VA
529-804 Receptacle assembly consisting
of a UL Listed 2x4 junction box
andULListedreceptacle
a. Enclosure part number ZB-X-XXXX, where the first
X c an be 9 or an y letter from A to N represents the
type of TEC module installed/to be installed in the
enclosure, and XXXX c an be any 4 alphanumeric
characters represent the TEC HVAC application.
For smoke control application, primary
rating is only 120V/ 60 Hz.
Parts for CE Compliance:
550-705
Clamp-on ferrite filter (10 pack)
588-100 series
Approved 2-RJ11 RTS cable in 25’,
50’, or 100’ (7.6-m, 15.2-m, 30.48-m).
Warning/Caution Notations
WARNING:
Personal injury/loss of life may occur if you
do not follow the procedures as specified.
CAUTION:
Equipment damage or loss of data may
occur if you do not follow the procedures
as specified.
Expected Installation Times
10 minutes.
Required Tools and Materials
• Electro-Static Discharge (ESD) wrist strap
• Flat-blade screwdriver (1/8-inch blade width).
•Smallflat-blade screwdriver
• Cordless drill/driver set
Page 2 of 6 Siemens Building Technologies, Inc.