Commissioning Instructions
Table Of Contents
- Before You Begin
- Verifying Power to the Controller
- Enabling Actuators
- Setting the Application
- Setting Number of Heat Stages or Valves
- Enabling Autozero Module
- Selecting Automatic Calibration Option
- Setting Room Temperature Setpoints
- Setting Override Time
- Enabling Wall Switch
- Setting Fail Mode
- Setting Duct Area
- Setting Flow Coefficient
- Setting Airflow Setpoints
- Setting Controller Address
- Secure Mode
3
Siemens Industry, Inc. Start-up Procedures 140-1020
2015-05-07
Table of Contents
Before You Begin ............................................................................................................... 4
Verifying Power to the Controller ......................................................................................... 4
Enabling Actuators ............................................................................................................... 4
Specifying Motor Setup ........................................................................................ 5
Setting the Application ......................................................................................................... 7
Setting Number of Heat Stages or Valves ........................................................................... 7
Enabling Autozero Module................................................................................................... 8
Selecting Automatic Calibration Option ............................................................................... 8
Setting Room Temperature Setpoints ................................................................................. 9
Setting Override Time ........................................................................................................ 10
Enabling Wall Switch ......................................................................................................... 10
Setting Fail Mode ............................................................................................................... 10
Setting Duct Area ............................................................................................................... 10
Setting Flow Coefficient ..................................................................................................... 10
Setting Airflow Setpoints .................................................................................................... 11
Setting Controller Address ................................................................................................. 11
Secure Mode ..................................................................................................................... 12