Operating Instructions
Table Of Contents
- Table of Contents
- How To Use This Manual
- Chapter 1—Hardware
- Chapter 2—Applications for ATEC— Base VAV
- Chapter 3—Applications for ATEC—VAV with Reheat
- Chapter Overview
- Introduction
- Application 2500: VAV Cooling Only
- Application 2501: VAV Cooling or Heating
- Application 2522: VAV with Electric Reheat or Baseboard Radiation
- Application 2523: VAV with Hot Water Reheat (only one reheat valve)
- Application 2524: VAV Series Fan Powered with One Stage of Electric Reheat
- Application 2526: VAV Parallel Fan Powered with One Stage of Electric Reheat
- Application 2473: Slave Mode
- Chapter 4—Point Database
- Chapter 5—Troubleshooting
- Glossary
- Index
Chapter 3—Applications for ATEC—VAV with Reheat
3-14 Siemens Building Technologies, Inc.
1. See Sequence of Operation, Control Temperature Setpoints.
2. See Sequence of Operation, Heating/Cooling Switchover.
Figure 3-5. Application 2501 Control Schedule.
Hardware Inputs
Analog
• Air velocity sensor
• Duct temperature sensor (optional)
• Room temperature sensor
• Room temperature setpoint dial (optional)
Digital
• Night mode override (optional)
• Wall switch (optional)
Hardware Outputs
Analog
• None
Digital
• Autozero module (optional)
• Damper actuator (wired internally)