User Manual

2/13
Building Technologies CC1N7814en
02.02.2018
Supplementary documentation
Product type
Type of
documentation
Documentation number
LMV5... Basic documentation P7550
AZL5... User documentation A7550
Warning notes
To avoid injury to persons, damage to property or the environment, the following
warning notes must be observed!
Do not open, interfere with or modify the actuators!
∂ Read the documentation on the actuators carefully and fully. If not observed,
dangerous situations can occur
∂ The user must ensure that the actuators meet the requirements of the relevant
application standards
∂ Safety-related applications are only available with Siemens burner controls
∂ All product-related activities (mounting, settings and maintenance) must be
performed by qualified and authorized personnel
Attention!
∂ Risk of electric shock – to disconnect the equipment from the power, it may be
necessary to open more than one switch. Before performing maintenance work,
the equipment must be disconnected from power
∂ The electrical connection between the conduit fittings is not made automatically.
It must be established on installation site
∂ The connecting plate is made of plastic and does not provide earthing of the
conduit fittings. Earthing must be ensured by adequate washers and wire links.
∂ To ensure protection against electric shock, the connection terminals must have
adequate protection. Make certain that non-insulated connections or wires cannot
be touched
∂ Each time work has been carried out (mounting, installation, service work, etc.),
check to ensure that wiring is in an orderly state
∂ Fall or shock can adversely affect the safety functions. Such units must not be put
into operation, even if they do not exhibit any damage
∂ Static charges must be avoided since they can damage the electronic components
on contact.
Recommended: Use ESD equipment
Notes on use in North America
Only flexible conduits with relevant accessories may be used.