Installation Instructions

Installation Instructions
Document No. 129-267
August 31, 2020
ASY97
Conduit Connector for SSA/P, SSB and SSD
Actuators
Item Number 129-267, Rev. DA Page 1 of 2
Product Description
This conduit connector is designed to be used with the
SSA…, SSB…, SSD…, and SSP actuators.
Installation Conventions
WARNING
Personal injury/loss of life
may occur if a procedure is
not performed as specified.
CAUTION
Equipment damage, or loss of
data may occur if the user
does not follow a procedure
as specified.
Product Number
ASY97 (package of 1)
Required Tools
Small flat-blade screwdriver
Estimated Installation Time
10 minutes
Prerequisites
WARNING:
Disconnect the controller power before
removing the installed terminal connector
and attaching the conduit connector.
Instructions
If you are attaching the conduit connector to an actuator
that is not currently wired, begin with the instructions in
the Attaching the Conduit Connector to the Actuator
section.
Removing the terminal connector from the
actuator
Figure 1.
1. Using a flat-blade screwdriver, loosen the terminal
connector.
2. Separate the terminal connector and the terminal
plug from the actuator.
3. Remove the terminal plug from the connector.
4. Disconnect the wires from the terminal plug. Save
the terminal plug.
Attaching the Conduit Connector to the
Actuator
1. Insert the wires or cable through the conduit
connector.
Figure 2.