User Manual

CE2B2463en AUD3 20.02.2008
Make full use of the electronic time
switch incorporated in the heating
controller
Operating Instructions
You want to set the correct time of day
1. Move the red slide switch to .
2. Press button of the current weekday (Day).
1 = Monday, 2 = Tuesday, 7 = Sunday
3. Press button
or until the correct time of day is
reached.
4. Set the red slide switch to
.
5. Clock is running; the period flashes at an interval of
one second.
You want to become familiar with the display
− The current weekday is underlined
− Indication of current heating mode:
heating to the NORMAL temperature
heating to the REDUCED temperature or the PRO-
TECTION temperature (depending on the selected
controller operating mode)
You want to become familiar with the 24-hour
program
You can call up all times that have been entered.
1. Move the red slide switch to
2. Press button of the weekday whose times you want to
see.
3. Press the Set button.
4. The time
for the first change from REDUCED/
PROTECTION to NORMAL appears.
5. Press the Set button.
6. The time
for the first change from NORMAL to
REDUCED/PROTECTION appears.
7. Etc.
8. Reset the red slide switch to .
You want to change a 24-hour program
The controller is supplied with the following standard 24-
hour program: heating to NORMAL temperature from
06:00 to 22:00.
1. Move the red slide switch to
.
2. Press buttons of the weekdays whose times you want
to change.
3. Press the Set button.
4. The first switchover time appears. The weekdays that
use the same switchover times flash.
5. Press the Set button repeatedly until the switchover
time to be changed appears.
6. Press button
or , to change the switchover time.
To cancel a heating period completely, enter
-.-- for both start and end (to do this, enter 00:00 and
press button
).
7. Press the Set button.
If the weekend settings shall be different from the
other weekdays, first enter the times for the entire
week and then change days 6 and 7 individually.
If you need to change a large number of time set-
tings, it may be of advantage to make a reset and
then start again.