User's Manual

AyTerminal User Manual for AyCare
Contents V2.1
Baby Phone
Start
Activation time
Autostart
Notifiers
Baby Phone
Triggers
Duration
Overview
Start
Start
Activation t
Autostart
Baby Phon
Triggers
Duration
Overview
Baby Phon
Figure 4-21 “Baby Phone” menu in STANDARD and JUMBO modes
For each mode the mode menu contains the following options:
• Start
– Starts the mode.
• Activation time
– Enables to set activation start time and activation end time for this mode and to
activate it. For details refer to chapter 4.4.1.
• Autostart
- Configures whether the mode should start automatically on AyCare start-up. For
details refer to chapter 4.4.2.
• Notifiers
– Configure mode’s notifiers.
• Triggers / Phone number
– Enables to configure the alarm triggers of the current mode.
• Duration (only for “Baby Phone” mode)
– Enables to configure the time period after that the mode again can trigger an alarm
after a previous alarm was handled. If the duration is set to 0 then on alarm
triggered the AyTerminal remains in alarm state until the mode is deactivated with
the deactivation code.
• Overview
– Presents an overview of the current mode settings.
In the mode menu screen, the mode name is displayed as title. No status icons are displayed in
this screen. The scroll bar indicator is always shown.
As long as no mode is started the green LED will blink.
The available buttons and screen’s functionality are the same in all menu screens.
4.4Configuring a mode
All modes are configurable via AyTerminal. The AyCare AyApplication allows configuring when an
alarm should be triggered and which are the notifiers to be informed. In order to be able to start a
mode, at least one trigger must be activated. If no alarm trigger is activated, then a message box
will be shown with a proper message and the mode will not be started. All notifiers can be
deactivated. No warning message is shown in this case.
Page 26 / 50