User's Manual

AyTerminal User Manual for AyCare
Contents V2.1
One phone number is the currently set phone number (e.g. [phone]). If the phone number
is not defined then the “<Enter Nr.>” line will be displayed in the menu.
The available buttons and screen’s functionality are the same as in all menu screens.
For Listen-in a phone number can be added/ modified through a phone editor screen (Figure 4-38).
If Listen-In is active then the phone with the specified number will be able to listen where the
AyTerminal is placed after establishing a voice call with the AyTerminal. The voice call in this case
does not trigger the AyTerminal to play any ring tone. The connection is made silently and
automatically.
+385316_
Phone number
OK
1
0
+
+385_
Phone num
OK
0
+
Figure 4-38 Set phone number screen (standard and jumbo mode)
The available characters are: + and 0…9.
By using the up/down navigation buttons you can browse the displayed digits, select them or select
OK. For adding a new digit it has to be selected and then the OK button (right button) has to be
pressed. To delete the last inserted digit press the Back button (left button). When no digit is
available in the input area, Back button (left button) can be used to cancel the editor; the previous
screen will be displayed.
To save the set value select the OK option and then press the OK button (right button).
If the phone number is not in international format then a message is shown and the editor is
displayed again.
No acknowledgment tone will be played in the screens above.
Only the defined phone numbers can listen in where the AyTerminal is placed.
4.4.4.2Noise
The following menu is provided for setting the noise parameters values:
Noise
Threshold
Active
Noise
Threshold
Active
Figure 4-39 Setup ego motion menu screen
Noise threshold can be changed in a noise adjustment screen (see Figure 4-40). Reaching or
exceeding this level will trigger the defined alarms.
For sensing the noise the AyTerminal microphone is used.
The alarm threshold can be defined in 100 steps of a range from 0 to 1000 dB
A
. On the screen the
threshold can be seen in percentages from 0 to 100%. Increasing step is 4%.
Page 34 / 50