User's Manual

AyTerminal User Manual for AyCare
Contents V2.1
Baby Phone
Noise=28%
Baby Phone
Noise=28%
Figure 4-45 Mode active and alarm triggered
4.6Deactivating a mode or triggered alarm
For stopping the triggered alarm the mode has to be deactivated.
Mode can be deactivated by pressing the deactivation code. After deactivating a started mode the
mode menu will be displayed. . If mode is started using “autostart”, after entering deactivation
code, main menu will be displayed.
For setting the deactivation code see chapter .
4.7Emergency call
The “Emergency call” menu item is used to make an emergency call.
<Mode n>
Emergency call
Settings
Turn OFF
Emergenc
Settings
Turn OFF
Figure 4-46 Main menu – standard and jumbo mode
4.8Settings
The “Settings” menu provides the possibility to configure general AyTerminal settings via its
submenus.
4.8.1AyServer Sync
This menu item gives the user the possibility to initiate synchronization with AyServer. While the
synchronization with AyServer is in progress on display the following screen will be visible:
Sync
In Progress
Sync
In Progress
Figure 4-47 Sync in progress
When the synchronization process is finished a message box is displayed informing about the
result of the synchronization. In case the synchronization failed the message box with the proper
message is displayed until right or left button is pressed. In case of success the message box with
the proper message will be displayed for 5 seconds. After 5 seconds the Settings menu is
displayed back.
Page 38 / 50