User's Manual

User Manual for AyCare AyTerminal
V2.1 AyCare application
Default settings
applied.
Rebooting...
Default
settings
applied.
Rebooting...
Figure 4-55 AyApplication warning message – standard and jumbo mode
The settings which are influenced by this reset to default are:
Setting Default value
Application version Current AyApplication version
All AySnapOns deactivated
Time Sync deactivated
AyServer Periodic Polling deactivated
AyServer Periodic Polling Interval 60s
Nickname John Doe
Deactivation code Up, Right, Down, Left
Audio - mute Deactivated
Audio – Voice Call volume Maximum (100)
Audio – Button Click volume Maximum (100)
Audio – Alarm volume Maximum (100)
Audio – Ring tone volume Maximum (100)
Audio – selected ring tone 3d in the list
Audi0 – headset Deactivated
Selected language EN
Display – jumbo mode deactivated
Table 4-5 AyTerminal settings – default values
For AyCare specific settings see chapter 4.2.4.
4.8.3.2Firmware Update
If registered to the AyServer the firmware update can be initiated. The AyTerminal will contact the
AyServer and if a newer firmware is found on the AyServer then the AyTerminal informs the user
that there is a new version available. The info is more a request for confirmation. To accept or
reject the download of the new firmware the right/ left button must be pressed. If the right button is
pressed then the new version of the firmware is downloaded on the AyTerminal and a positive
acknowledgment. is sounded. During the download a message screen is shown.
Before AyTerminal reboots a notifying message box is shown. If the left button is pressed in
confirmation screen then the firmware update is canceled and negative acknowledgment. is
sounded.
Page 41 / 50