User's Manual

User Manual for AyAlarm AyTerminal
V2.1 AyAlarm application
will be displayed in the menu. If the phone number is not defined then in the menu will appear
“<Enter Nr.>”.
Pressing the left button of the device leads to the previous screen.
In “Voice Call” menu the status icons are not displayed. Instead a suggestive title is displayed.
<Enter Nr .>
Active
Voice call
+2020202
Voice Call
Active
Figure 5-30 Voice Call setup menu
The phone number can be added or modified through a phone number editor:
+385316_
Phone number
OK
1
0
+
+385_
Phone num
OK
0
+
Figure 5-31 Set phone number screen
The available characters are: + and 0…9.
Using the up or down navigation buttons scrolling through displayed characters is possible or
selecting OK.
To add a new character press the Enter navigation button after highlighting the desired character.
To delete the last inserted character use the left navigation button. When no character is available
in the input area, pressing the cancel button redirects to the previous screen.
To save the set value first select OK option and after that press the right button.
The only validation that is made for the inserted phone number is to be in international format (to
start with +).
Only one phone number can be defined for SMS notification.
No acknowledgment tone will be played in previous described screen.
An established Voice Call can be ended by pressing long on the central button. If also voice call
and siren are set as notifiers first the voice call is established and after voice call is finished the
siren is played for the defined duration.
5.4.3.4AyServer
This notifier can just be activated/ deactivated. If the AyServer option is checked then an alert will
be sent to the AyServer when an event occurs. This item is only available if the AyTerminal is
registered to the AyServer (initial SMS was received from AyServer).
Activating or deactivating AyServer as notifier is done by checking or un-checking the option in the
“Notifiers” menu (see Figure 5-27). To check or uncheck AyServer item select it and after that
press the right button.
If the data needed to be able to connect to AyServer is not available in the system then the
AyServer item in “Notifiers” menu will be displayed strikethrough. A strikethrough item can not be
selected.