User's Manual

User Manual for AyAlarm AyTerminal
V2.1 AyAlarm application
Figure 3-4 Hold-switch
3.1.1Hold-switch
This switch prevents unintended button presses, see Figure 3-4. A button press is accepted only in
case the switch is in position “unlock”. If the hold-switch is in position “lock“ the only accepted
action is the long-press onto the central button, if this is enabled by AyApplication e.g. to enable
emergency calls.
If the AyTerminal is off, the hold-switch on “lock” and long press is performed the AyTerminal will
NOT turn on.
3.1.2Status LED
This status LED is used to provide feedback to the end-user about the current AyTerminal status.
The dual-color LED is able to show the following colors:
• black (off),
• green,
• red,
• orange (mixture between red and green).
The LED is able to blink within the range from once per 25 seconds (0,04Hz) to 10 times per
second (10Hz).
Following table shows the status of the Status LED depending on the AyTerminal status.
Status LED
color type
AyTerminal status
green permanent AyTerminal OFF, charger connected,
battery charging mode
red permanent AyTerminal OFF, charger connected,
battery charging error
orange permanent AyTerminal OFF, charger connected,
battery charging finished
green permanent AyTerminal ON, startup phase
orange/green blinking (500msec
ORANGE, 500msec
GREEN)
AyTerminal ON, startup phase, firmware
update
green/black blinking (100msec
ON, 2000msec OFF)
AyTerminal ON, mode active or idle
orange/black blinking (100msec
ON, 2000msec OFF)
AyTerminal ON, shutdown phase
(selection of Turn OFF item)
green/black blinking (100msec
ON, 200msec OFF)
AyTerminal ON, GPRS/SMS/GSM
transmission
•
red/black blinking (300msec
ON, 300msec OFF)
AyTerminal ON, error indication like:
• low battery,
• to many AySnapOn´s connected,
no SIM inserted
orange/black blinking (300msec
ON, 300msec OFF)
AyTerminal ON, AyApplication alarm is
triggered
red permanent AyTerminal ON, critical error, device
Hold-switch