Specifications

Mobility and Logistics, Traffic Solutions
Sopers Lane, Poole, Dorset, BH17 7ER
Security classification Unrestricted Page 61 of 83
Version 2 Status Released
Last Editor Harry Smyth Date 09/12/2014
Document Name Configuration Control Document No. 667/CC/45950/000
Copyright © Mobility 2014. All Rights Reserved. Mobility is a division of Siemens Plc
Figure 47 shows the connections of the serial link to the first Intelligent Detector Backplane.
Intelligent Detector Backplanes are connected using Cat5e cable. The sequence of
connection set out in Table 5 should be followed. The GSPI serial link is connected from the
first Intelligent Detector Backplane OUT socket into the second Intelligent Detector
Backplane IN socket. This sequence of connections should be followed for connection
between first Intelligent Detector Backplanes and the final Intelligent Detector Backplane.
Please also note that a separate infrared connection is required for SLD4 automatic set-up.
This link operates horizontally and therefore SLD4 cards must be mounted alongside each
other to communicate in this fashion. Please refer to Figure 47 which shows the required
connection to continue this link vertically.
Figure 47 – IDB Serial Connection
View Intelligent Detector Backplane with comms PCB removed
Detector
Power IN
Detector
Power OUT
to next
Intelligent
Detector
Backplane
Connection
from Loop
Termination
PCB PL8
Fast Serial
Link from
I/O card
Fast Serial
Link to next
Intelligent
Detector
Backplane
Serial I/O
Address
Switch
Backplane
isolation fuse
Infrared link
Input from
previous
SLD4 in level
above
Infrared
Output to
next SLD4 in
level below