Operating Instructions
Chapter 4 - Parameters and Menu Structure
User Settings (M6)
169 | 187
Siemens Industry, Inc.
Siemens BT300 HVAC Drive
DPD01809
Smart Infrastructure
2019-05-29
3. Select:
Main Menu > I/O and Hardware (M5) > Ethernet (M5.9) > BACnet IP (M5.9.3) > Settings
(M5.9.3.1) > Protocol in use (M5.9.3.1.3) > Edit.
4. Set to a value of 1.
5. Select:
Main Menu > I/O and Hardware (M5) > RS-485 (M5.9) > BACnetMSTP (M5.9.3) > Parameters
(M5.9.3.1) > Instance Number (M5.9.3.1.4) > Edit.
6. Enter the desired
device instance number between 0 and 4194303.
For commanding of Run/Stop using BACnet/IP complete the following steps (in
addition to the Monitoring steps above):
1. Select:
Main Menu > Quick Setup (M1) > Ctrl. Place Auto (M1.15) > Edit.
2. Select
FieldBusCTRL
For commanding Speed Reference using BACnet/IP complete the following steps (in
addition to the monitoring steps above):
1. Select:
Main Menu > Quick Setup (M1) > I/O A Ctrl Ref (M1.10) > Edit.
2. Select
Fieldbus.
User Settings (M6)
User settings (M6) are drive- and keypad-specific settings. This section contains the following information:
Table 134: User Settings.
Menu and Parameter Group
Description
Language Selection (P6.1)
Selection of the language the keypad is displayed in.
Parameter Backup (M6.5)
Backup and restore functions for the drive.
Parameter Compare (M6.6)
Parameter comparison to defaults, or backup files.
Drive Name (P6.7)
User-defined name for the drive.
User settings (M6) contain the following parameters:
Structure
Parameter
ID
Description
P.1
Language Selections
802
Selection of the language for the keypad use. This varies depending upon the language
package installed.
P6.5
Parameter Backup
See
Parameter Backup (M6.5).
P6.6
Parameter Compare
See
Parameter Backup (M6.5).
P6.7
Drive Name
2528
User-defined name for the drive. Default value is the serial number of the drive.
Parameter Backup (M6.5)
The parameterization can be used to restore the drive to factory default values, stored in and restored from
keypad, backup set 1 (in the drive), and backup set 2 (in the drive).