Installation Instructions

DPD01159% Siemens Industry, Inc.

Panel Adapter Kit - Mounting Instructions

Introduction

The Panel Adapter is intended to replace the standard keypad in cases where keypad is not needed.The Pan-

el Adapter is Type 12/IP54 protected.

For the installation, you need the following parts included in the delivery. Make sure that you have received

all necessary parts!

Figure 1. Panel adapter mounting kit

1. Cover A

2. Cover B

3. Screws PT3.5 x 8 (4 pcs)

4. Foam rubber gasket

Indication LED

The LED on the Panel adapter gives indications about the status of the drive.

Note the location of the LED in picture to the right.

LED indication Meaning

Blinking slow (1 s ON - 1 s OFF)

Drive works normally (software

running)

Blinking fast Software is loading

Indication LED

PAGE 1
Siemens Industry, Inc. DPD01159% Panel Adapter Kit - Mounting Instructions Introduction The Panel Adapter is intended to replace the standard keypad in cases where keypad is not needed.The Panel Adapter is Type 12/IP54 protected. For the installation, you need the following parts included in the delivery. Make sure that you have received all necessary parts! 2 1 3 3 4 Figure 1. Panel adapter mounting kit 1. 2. 3. 4. Cover A Cover B Screws PT3.
PAGE 2
Siemens Industry, Inc. DPD01159% Mounting procedure Attach the transparent cover B to the keypad base using the two screws provided.Tighten the screws to max. 1 Nm (8.85 lbf-in). 1 2 If a connection cable for the keypad is needed detach the foam rubber gasket from the cover and punch out the cylinder-formed piece of foam rubber in order to open way for the cable. The gasket can then be split into two pieces. Then attach the black cover A with the two screws provided. Tighten the screws to max.