User Manual

69
AUTOMATIC CONTROL
6 BLIND CONTROL BT Reason for energy savings
There are two different motivations for blind
control: solar protection to avoid overheating and
to avoid glaring
1
0
Manual operation
Mostly used only for manual shadowing, energy
saving depends only on the user behavior
Usually, manual interventions are only made for
glare protection. Energy savings are highly
dependent on user behavior.
1
Motorized operation with manual control
Mostly used only for easiest manual (motor
supported) shadowing, energy saving depends
only on the user behavior
Motorized support only eases manual
intervention and is mostly only done for glare
protection. Energy savings are highly dependent
on user behavior.
2
Motorized operation with automatic control
Automatic controlled dimming to reduce cooling
energy
2
Motorized support is required for automatic
control.
The focus of automatic control functions is in the
support of solar protection, reducing the heat
input such that cooling energy can be saved.
Manual operation by the user must be possible
at all times, allowing the user to achieve glare
protection independent of automatic solar
protection control for energy savings.
3
Combined light/blind/HVAC control
To optimize energy use for HVAC, blind and
lighting for occupied and non-occupied rooms
3
This processing function considers all the
reasons to meet the needs of the use and
energy-optimized (prioritized consideration for
occupied and non-occupied rooms).