User Manual

Building Operator Engineering Guide
Setting Up Connect Device and Building Operator
1
A6V11881627_en_k
13 | 69
case, connect the LAN cable to your building automation network, and your
WAN to the Internet.
– Single network mode: Select this option if your building automation
network, and the Internet, use the same physical network connection. In
this case, the use the WAN for both the Internet and building automation.
CAUTION
This selection is not reversible. A factory reset is required to change this
selection, which will result in loss of existing network configuration and project
data.
1. The following warning message will display if you select Single network mode.
See the Cybersecurity Guidelines (A6V11852371) document for further details.
2. To configure alternative IP and proxy settings, click the IP settings tab under
the Network tab.