User Manual

Building Operator Engineering Guide
Setting Up Connect Device and Building Operator
1
A6V11881627_en_k
17 | 69
Assigning distributions
After adding and activating the device, you will need to assign the distribution to
enable Building Operator Discovery. To assign a distribution to the device, follow
the steps below.
Assigning a distribution set will only need to be done once. The assign distribution
pop-up will only appear after adding a device in a site. If you do not assign a
distribution, this pop-up will appear until the device is assigned a distribution.
 In Asset Manager:
1. Go to Sites.
2. Select the site with the Connect X300 device..
3. Select the device.
4. Go to Applications.
5. In the pop-up, select the distribution and distribution version> Click Save.
Updating distributions
To update a distribution on a device, follow the steps below.
 In Asset Manager:
1. In the sites tab, select the site with the Connect X300 device.
2. Select the device
3. Navigate to the Applications tab.
4. To update the distribution, click Update.