User Manual

Building Operator Engineering Guide
Adding Data Points Using Building Operator Discovery
1
A6V11881627_en_k
39 | 69
Adding Data Points
Similar to discovering equipment, you can discover points to add to the equipment
you just discovered. To discover points for specific equipment in Building Operator
Discovery, complete the following instructions:
1. In the floor object, find and select the right device. Three icons appear once
you hover over the device name. Select the arrow icon, closest to the device
name, to set that device as your current context in Building Operator Discovery.
2. After setting the context, you will see a breadcrumb trail that reflects this action
in the menu bar above.
3. Once you’ve set the proper context, find and select the appropriate device
controller in the Connectors node. Select to expand Connectors, then BACnet
(or whichever type of connector you’re using).
4. Find and select the connector you want to add points to. Then, select Discover
Points, below the Added Points list results (there will be none, if you haven’t
added any yet).