User Manual

Building Operator Engineering Guide
Setting Up Connect Device and Building Operator
1
10 | 66
A6V11881627_en_i
➅
Display Port Interface (unused)
➆
Serial interface, 9-pin for RS 232, EIA-422, EIA-485 (unused)
➇
X1P1 = LAN (customer network) Ethernet 10/100/1000 Mbps (with 2 LEDs per port for
indicators)
➈
X2P1 = LAN (internet access) Ethernet 10/100/1000 Mbps (with 2 LEDs per port for
indicators)
There are multiple LED lights on the Connect device. The table below outlines
each light’s function:
1. In the Connect device landing page, select Accept to verify you’ve
acknowledged the end user license agreement.
2. Next, enter the following credentials in the fields provided:
– Username: admin (case-sensitive)
– Password: admin (case-sensitive)
3. Next, complete the prompt to change the default password. This password is
specific to the Connect device you are logged in to. Select a password that
complies with the following guidelines:
– At least 8 characters
– Uppercase and lowercase letters
– Numbers
– Special characters
4. Select Change Password when finished.