User Manual

Building Operator Engineering Guide

Adding Data Points Using Building Operator Discovery

A6V11881627_en_i

47 | 66

1. Find and select the appropriate value or output point beneath the device, in the

Available Equip tree.

2. In the point editor, find the Write Level field.

3. Use the up or down arrows, or type to enter 8 for the field value. Any command

you send to the Building Operator Discovery priority array will be sent out to the

end BACnet device at slot 8, or manual override.

4. Select Save at the bottom of the editor to save your changes.

1.3.9 Restarting Connect Device to Update Data Point

Information

If you want to update data point information or change it for any reason, you’re able

to do so in Building Operator Discovery.

However, any data point information you update in Building Operator Discovery

won’t appear in Building Operator until there’s a change of value (COV) on that

specific data point. To force a COV, as an Administrator, you must restart the

Connect device. The example below outlines how to restart the gateway to force a

COV.

To restart the Connect device to update data points:

1. Navigate to the point you want to change in the Available Equip Tree (Site >

Floor > Equipment > Data point) and type to enter the revisions in the

appropriate field(s). In this example, we’re adding

“(SieSte20)”

to the end of the

AOV2 data point name.

2. Select Apply when finished.

3. In a separate browser tab, log in to Connect device. Use the same username

and password you created earlier when you first activated the device.

4. Select the Maintenance tab in the navigation ribbon.