User Manual

Building Operator Engineering Guide
Setting Up Connect Device and Building Operator
1
A6V11881627_en_i
9 | 66
☐ Adding Tags to Data
Points
device to add equipment,
data points, and alarms.
☐ Determining BACnet
Write Priority for Points
☐ Restarting Connect
Device to Update Data
Point Information
☐ Configuring Alarms in
Building Operator
Discovery
☐ Backing Up and
Restoring a Building
Operator Discovery
Database
1.2.2 Setting up Connect Device
This section will cover the installation, network choice, and log-in credentials for the
Connect device.
To install the Connect device, complete the instructions below.
◈
Connect to the LAN port X1P1 and open a new browser window. In the
browser address bar, type the following IP address: 169.254.169.254.
 The network patching configuration should look as follows:
– Single network mode (combined): WAN in port X2P1.
– Separate network mode (isolated): WAN in port X2P1, LAN in port X1P1.
Only LAN X1P1 supports the local connection to Connect device. LAN and WAN
in different networks must have different subnets.
➀
Protective earth
The protective earth connection must be connected on the installation side with the
building grounding system (PE).
Min. diameter: 2.5 mm
2
/ 14 AWG)
➁
Pluggable Terminal Block for operating voltage DC 24 V =
➂
ON/OFF Switch, OFF when pressing
➃
USB 2.0, 3.0 interfaces (unused)
➄
Serial interface, 9-pin for RS 232, EIA-422, EIA-485 (unused)