User Manual

Installation
Please take a little time to fully read these installation and user instructions
so as to gain the most from your BUP2.
1. First remove the backplate from the BUP2 by undoing the two small
screws at the base of the unit and lift out from the bottom so that the two
lugs at the top disengage from their positions.
2. Prior to installing onto the backplate, insert the battery into the battery
tray (see Fig. 1) and ensure that positive + and negative - are correctly
installed. The battery is a non-rechargeable lithium cell and in the event of
power failure will protect your programme instructions for up to 365
continuous days of power loss.
3. The BUP2 is factory set to provide 2 on/off switching periods per day and
each day will be the same, i.e. daily operation. To select the other styles of
switching you will have to alter the dip switches which are to be found at the
bottom rear of the unit (see Fig. 1) into the relevant position for the style of
operation you require.
NB Press RESET after any dip switch change.
BUP2 installation instructions 14/4/07 11:39 AM Page 3