User Manual

5. Once you have completed the above you are now ready to connect the
BUP2 to the backplate, If the BUP2 is replacing another Landis & Gyr or
Landis & Staefa product as listed below no wiring changes are required,
RWB1, RWB2, RWB9, RWB20, RWB40, RWB200, RWB200cw, RWB252,
RWB252cw, RWB270, RWBXP, Gloworm Mastermind, Potterton Miniminder,
Sankey Sunline.
6. If the BUP2 is replacing another Landis & Gyr or Landis & Staefa product
as listed below, these products are NOT suitable for replacement by the
BUP2. Return the BUP2 to your stockist/installer and request the BUT2 which
will fully interface with your old units backplate.
with the exception of the RWB3 which will require a link inserted from L to
2 on the existing backplate RWB3, RWB7, RWB30, RWB50, RWB100, RWB152,
RWB152cw, RWB170 and RWBXT.
7. Mounting Location
To ensure convenience of use, the BUP2 should be fitted in a position
which allows easy access. It is recommended that the unit is placed at a
height of 1.4 metres from the floor, and should not be installed where either
extremes of heat or cold exist. Care should also be taken to ensure that
steam, water or oil cannot splash onto or enter either the BUP2 or its
backplate.
BUP2 installation instructions 14/4/07 11:39 AM Page 5