User Manual

10. Fitting the Unit to the Backplate
Tilt the bottom of the case away from the wall, and locate the two slots in the
top of the case over the two tabs at the top of the backplate. Push the bottom
of the case towards the wall, slotting the two backplate screws into the
bottom of the case, and tighten the screws. This enables the contacts in the
unit to engage with those in the backplate.
Technical Data BUP2
Preset Factory Settings
2 on/off
6.30am to 8.30am and 4.30pm to 10.30pm
Supply: 200/240V 50Hz
Power Consumption: 50mA
Contact rating: 6A (resistive)
2A (inductive)
Switching voltage: 240V
Ambient temperature range: 0 to 40°C
Environmental humidity: 80% RH
Housing: Fire-retardant ABS material
BUP2 installation instructions 14/4/07 11:39 AM Page 8