Security Camera User Manual

Description of the equipment

Siemens Building Technologies

Fire Safety & Security Products 05.2009

6.6 Hardware reset

There is a reset button on the back cover of the network camera (see chapter 6.2

Front and rear views of the camera, No. 5). It is used to reboot the network camera

or to reset the network camera to the factory default configuration. Depending on

the functional problem, rebooting may set the network camera back to normal

state. If the problem remains after rebooting, restore the network camera settings

to the factory default and install the software again.

Reboot:

Press and release the reset button. The status LED on the front will blink red.

Restore:

Press the reset button continuously until the status LED on the front blinks in red

and green simultaneously. Note that all settings will be reset to factory default.