Security Camera User Manual

Upgrade firmware

Siemens Building Technologies

Fire Safety & Security Products 05.2009

11 Upgrade firmware

This feature allows you to upgrade the firmware on your network camera. It takes

about five minutes to complete the process.

WARNING

Do not power off the network camera during the upgrade process and ensure

that the PC running the upgrade software (Installation Wizard / Web Browser) is

running stable. Otherwise the camera will be rendered defective (out-of-

warranty).

There are two ways to upgrade the firmware:

z Using the CCIC1410 Homepage

z Using the CCIC1410 Installation Wizard

11.1 Using the CCIC1410 Homepage

1. Download a new firmware file from SIEMENS website:

http://www.siemens.com/ip-cameras. The file is in pkg file format.

2. Open the CCIC1410 Homepage (see chapter

9.1).

3. Choose the Configuration menu.

4. On the left hand side, choose the menu item Maintenance.

5. In the Upgrade firmware section, click Browse and select the correct

firmware file.

6. Click Upgrade.

Î The network camera starts to upgrade and will reboot automatically when

the upgrade is complete.

Î The message “Reboot system now!! This connection will close”

indicates that the upgrade was successful.

7. Re-access the network camera.

11.2 Using the CCIC1410 Installation Wizard

NOTE

The CCIC1410 Installation Wizard allows you to upgrade several devices (of the same model) at the

same time. If you select different models, then the Firmware Upgrade button will be disabled.

1. Select one device or several devices in the device list on which you want to

upgrade the firmware (see chapter

8.3.1: Select a device for the

configuration).

2. Click the Firmware Upgrade button on the left side.

Î The following window appears: