User Manual

Cerberus Division

Make file ABS

14[34]

Data and design subject to change without notice. Supply subject to availability

02.99 e1754.doc

You can use the ABS file with an EPROM programmer to generate the EPROM to be

installed in the Gateway. Please refer to ANNEX A - EPROMs supported section for a

detail about the EPROM chips to be used.

You can alternatively generate and download the file to the Gateway using the SLTA

(LonWORKS) connection. To do so, access the option 2 of the main menu, labeled

"Download". The process is basically identical to the one described above, but at the

end of the generation of the ABS file the program runs a communication process to-

ward the Gateway. If the communication fails you get the following message.

Connection to slta ...

Wrong connection: Could not open network driver

The third option of the Main menu can be used to detect the EPROM version installed

in the Gateway. It requires that the PC you are working on is connected through the

SLTA to the Gateway.