User Manual

Cerberus Division

Introduction

e1754.doc

Data and design subject to change without notice. Supply subject to availability

land 1999

02.99 1

1 Introduction

1.1 The aim of this manual

This manual provides all of the information and instruction necessary to use the

GW21 Configurator Program.

GW 21 Configurator is the software used to configure the EPROMs needed by the

Gateway GW-21 to operate properly.

The manual explains in detail how to set the relevant parameters for each Pad inside

the gateway, how to configure the interactions among subsystems and how to set the

reaction programs. GW21 Configurator lets you define these parameters in a

straightforward way, checks the configuration consistency and eventually generates

the code needed by the EPROM programmer to set up the EPROM.

To fully understand the meaning of the terms used in this manual, please refer to the

following documentation:

LMSmodular Installation manual e1116

LMSmodular User manual e1108

LMSmodular Configuration Guide e1109

LMSmodular Configuration Reference e1252

LMSmodular Guard Tour

Configuration and Installation manual e1310

LMSmodular Graphic Station Installation manual e1266

LMSmodular Software Product description e1428

LMSmodular System description e1429

LMSmodular Application Examples e1430

LMS Access Control Installation Manual e1357

LMS Access Control User and

Configuration Manual e1358

1.2 Who this manual is for

This manual is addressed to Cerberus personnel who must prepare the Gateways to

fit the specific customer requirements.