User Manual

3
Fire & Security Products
Siemens Building Technologies Group
01.2004
In the Composer project, MK8000 and MM8000 should be configured to include the
new CDI-WAN driver NS8210, which is one of the standard drivers available.
Note: NS8210 actually replaces the NK8210 router that used to be installed with
LMSmodular software.
Limitations
MK8000 and MM8000 cannot be connected to NK822x MP2.1 over serial line. A
technical difficulty in the configuration tool currently causes this limitation, which will
soon be removed.
Serial-based solutions for MK8000 MP1.3 and MM8000 MP2.3 can be realised using
CDI.WAN MP1.1 (R1.31) product and tools. See DMS8000 Connectivity Guide
(007083) for more information.
CDI-WAN MP2.1 can provide support for up to 50 networked NK822x’s. It is planned
to remove this limitation in next market packages.
2.3 New software tools
In comparison with MP1.1 (R1.31) software, MP2.1 has partially replaced the tools.
Tool Application Used in MP2.1 Status
NW8201 General configuration tool No Composer has replaced NW8201, which
is no longer distributed.
NW8202 Initialisation tool, required Yes
(1)
NW8202 is still used for initial setting
for IP address setting of the IP address. It is distributed with
MM8000 and MK8000, and requires a
separate set-up to be installed.
NW8203 Update tool, required for No NW8204 has replaced and outperformed
downloading new firmware NW8203. See  CDI-WAN MP2.1 ICC
manual (007798).
NW8204 Maintenance tool Yes
(2)
New NW8204 is distributed with
MM8000 and MK8000, and requires a
separate set-up to be installed. It can
provide:
- Download of new software
- Upload of diagnostic logs
- Advanced FTP
Notes:
(1) NW8202 for CDI-WAN MP2.1 is not compatible with CDI-WAN MP1.1 (R1.31) products
On the other hand, NW8202 for CDI-WAN MP1.1 cannot be used for MP2.1.
Be careful in using the correct tool version!
(2) NW8204 is described in CDI-WAN Installation, Configuration and Commissioning.