User Manual

Test equipment and accessories
StabexHF
Test lamp for flame detectors 'Ex'
Part no.
BPZ:4620910001
Document
Product data sheet
000252, A6V10203222
Application
The test lamp is used to carry out a performance check of intrinsically safe flame detectors in explosion-
hazard areas of zones 1 and 2.
Technical data
Operating temperature
-20…+40 °C
Storage temperature
-20…+40 °C
Battery capacity
2 x Alkali battery 1.5 V, single-cell UM1
Ex-classification
II 2 G Ex ib e IIC T4
Protection category EN 60529/IEC 60529
IP65
Approvals
PTB 98 ATEX 2062
9.7 Adapter for C-NET devices
FDUZ227
MCL USB adapter
Part no.
S54323-F106-A1
Document
Product data sheet
A6V10355605
Installation
A6V10347735
Application
The MCL USB adapter is an interface converter for USB to MC link. It can be used to connect FDnet
devices or C-NET devices to a PC using a serial protocol (MCL).
Function
The adapter is used for floor repeater display FT2011-A1, for floor repeater terminal FT2010-A1, for
radio gateways FDCW221 & FDCW241, for detector exchanger and tester FDUD292/293 and for line
tester FDUL221 (in the future other FDnet devices possible).
The SWING devices FDOOT271 & FDCW241 can communicate via radio with the FDUZ227 (in the
future other SWING devices will be possible). The radio communication requires the tool FXS2061.
Technical data
Power supply
via USB (5V)
Interface
USB 2.0, MC link, FDnet, radio
Operating temperature
-10…+55 °C
Storage temperature
-20…+60 °C
Humidity
≤95 % rel.
Dimensions (WxHxD)
100 x 30 x 54 mm
Protection category
IP30
101
Building Technologies
058_FD720_Equipment_overview_A6V10225323_j_en.doc
CPS Fire Safety 04.2014