User Manual

Test equipment and accessories
RE6T
Detector tester for heat detectors
Part no.
BPZ:3680270001
Document
Product data sheet
A6V10203222
Application
This detector tester contains a hot air generator. For the performance check, the tester is pushed over
the detector. The hot air released, heats the detector and so actuates an alarm.
The extension rod FDUM291/292 must be ordered separately.
Forbidden in electrical switching stations or areas where there is a danger of explosion!
Technical data
Mains voltage
AC 220 V / 50…60 Hz, ~300 W
Operating temperature
0…+40 °C
RE7T
Solo461 Heat detector tester kit
Part no.
A54370-S3-A1
Document
Product data sheet
A6V10252901
Anwendung
The detector tester contains a hot air generator. For the performance check, the tester is pushed over
the detector. The hot air released, heats the detector and so actuates an alarm.
The adaptor RE7T-A and the extension rod FDUM291/292 must be ordered separately.
Kit consists of:
– Tester
– 2 Battery batons
– Charger
Forbidden in electrical switching stations or areas where there is a danger of explosion!
Technical data
Operating temperature
5…+45 °C
Storage temperature
-10…+50 °C
Humidity
≤95 %
RE8ST
Testfire 1001-101 ST test kit
Part no.
S54370-S23-A1
Document
Product data sheet
A6V10397718
Application
The detector tester contains a smoke capsule. For the performance check, the tester is pushed over the
detector. The smoke released actuates an alarm.
The extension rod FDUM291/292 must be ordered separately.
Kit consists of:
– 1 Testfire 1001-101 tester
– 1 smoke capsule
– 2 Batteries
– 1 Charger (incl. 12V connection cable)
– 2 mAins cables (110 / 120-220 / AC 240 V)
– 1 USB cable
Forbidden in electrical switching stations or areas where there is a danger of explosion!
Technical data
Operating temperature
5…+45 °C
Storage temperature
-10…+50 °C
Humidity
≤95 %
94
Building Technologies
058_FD720_Equipment_overview_A6V10225323_j_en.doc
CPS Fire Safety 04.2014