Operating Instructions

59
FC2005 Desigo UL
FC2005 Desigo ULC
FC901 Cerberus UL
FC901 Cerberus ULC
STRI-S
x
x
STRI-D
x
x
STRI-M
x
x
SZM
x
x
SLIM
x
x
SFPO-11
x
x
SFPT-11
x
x
SFP-11
x
x
ILED-SC
x
x
ILED-SW
x
x
Other
PAD5
x
x
x
x
Notes:
1. Siemens SLC devices, detectors and modules, up to a maximum of 50 addresses may be used.
2. For specific wiring and installation information, read the instructions provided with each device.
3. If more than one HCP is used on a SLC device loop, the loop must be wired Class A or the riser
conductors must be installed in accordance with the Survivability From Attack By Fire
requirements in the National Fire Alarm Code, NFPA 72. If wired Class A, at least one HLIM loop
isolator must be installed between each HCP and between the panel and the first and last HCP.
See the HLIM installation instructions for the maximum number of isolators allowed per loop and
other wiring instructions.
4. FC2005 support FDOOTC441 CO functionality. CO channel can be configured as automatic alarm
event and supervisory event in the detection tree of the FC2005. But it does not comply with UL
2017 standard when the CO channel is configured for an automatic alarm event. It does comply
with UL 864.
5. H-series, 8700 series and S-series modules are the same devices with different sales channel.
Their corresponding relationship is shown in the below table:
H-series
8700-series
S-series
HFP-11
8713
SFP-11
HFPT-11
8712
SFPT-11
HFPO-11
8710
SFPO-11
HMS-S
8700-S
SMS-S
HMS-D
8700-D
SMS-D
HMS-M
8700-M
SMS-M
HMS-SA
-
SMS-SA
HMS-2S
-
SMS-2S
HTRI-S
8702
STRI-S
HTRI-R
8704
STRI-R
HTRI-D
8703
STRI-D
HTRI-M
8701
STRI-M
HCP
8706
-
HZM
8705
SZM
ILED-HC/HW
8726C/W
ILED-SC/SW