User's Manual

41
Operating the base station on the PABX
Gigaset C450 IP / GBR PTT / A31008-M1713-L151-1-7619 / settings_bs_hs_pabx.fm / 15.5.06
Version 4, 16.09.2005
Viewing/changing subnet mask
You can only change the subnet mask
(page 76) if you have deactivated
dynamic assignment.
§Menu§ ¢ Settings ¢ Base ¢ VoIP
Configuration (enter system PIN)
¢ IP
Configuration
¢ Subnet Mask
The current subnet mask is displayed.
~ If necessary, enter subnet
mask and press
§OK§.
Activating/deactivating display
of VoIP status messages
If the function is activated, a VoIP status
code for your service provider is displayed.
Activate the function e.g. if you have prob-
lems with VoIP connections. You will
receive a provider-specific status code,
which supports the service when the
problem is analysed.
§Menu§ ¢ Settings ¢ Base ¢ VoIP
Configuration (enter system PIN)
¢ IP
Configuration
Status on HS (‰ =on)
Select and press
§OK§.
Check the base station MAC
address
Depending on your network configura-
tion, it may be that you have to enter your
base station MAC address e.g. into your
router's access control list. You can check
your base station MAC address:
§Menu§ 4IO2Q
The base station MAC address is displayed.
a Press and hold (idle status).
Operating the base station
on the PABX
The following settings are only necessary
when your PABX requires them; see the
PABX User Guide. The settings only con-
cern fixed network connections.
You cannot send or receive SMS messages
on PABXs that do not support Calling Line
Identification.
Changing the dialling mode
You can set the dialling mode.
§Menu§ ¢ Settings ¢ Base ¢ Additional
Features
¢ Dialling Mode
Tone / Pulse
Select and press
§OK§ (‰ =on).
a Press and hold (idle status).
Please note:
For notes on the subnet mask, please see
page 46 and the glossary on page 76.
Please note:
For how to make the setting on the Web con-
figurator, see page 53.