Technical data

Parameters

List of Parameters

1-30

SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 01/2011

Description: Displays status word 1.

Caution: p2080 is used to define the signal sources of the PROFIdrive status word interconnection.

Note: The following status bits are displayed in r0052.

Bit 00: r0899 Bit 0

Bit 01: r0899 Bit 1

Bit 02: r0899 Bit 2

Bit 03: r2139 Bit 3 (or r1214 Bit 10, if p1210 > 0)

Bit 04: r0899 Bit 4

Bit 05: r0899 Bit 5

Bit 06: r0899 Bit 6

Bit 07: r2139 Bit 7

Bit 08: r2197 Bit 7

Bit 09: r0899 Bit 7

Bit 10: r2197 Bit 6

Bit 11: r0056 Bit 13 (negated)

Bit 13: r2135 Bit 14 (negated)

Bit 14: r2197 Bit 3

Bit 15: r2135 Bit 15 (negated)

r0052.0...15 CO/BO: Status word 1 / ZSW 1

Access level: 2 Calculated: - Data type: Unsigned16

Can be changed: - Scaling: - Data set: -

Units group: - Unit selection: -

Min Max Factory setting

- - -

Bit field: Bit Signal name 1 signal 0 signal FP

00 Rdy for switch on Yes No -

01 Ready Yes No -

02 Operation enabled Yes No -

03 Fault present Yes No -

04 Coast down active (OFF2) No Yes -

05 Quick Stop active (OFF3) No Yes -

06 Switching on inhibited active Yes No -

07 Alarm present Yes No -

08 Deviation, setpoint/actual speed No Yes -

09 Control request Yes No -

10 Maximum speed reached Yes No -

11 I, M, P limit reached No Yes -

13 Alarm motor overtemperature No Yes -

14 Motor rotates forwards Yes No -

15 Alarm drive converter overload No Yes -