Technical data

Parameters

List of Parameters

1-414

SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 01/2011

Description: Sets the signal source of minuend X1 and subtrahend X2 of instance SUB 1 of the subtractor.

Index: [0] = Minuend X1

[1] = Subtrahend X2

Description: Display parameter for the difference Y = X1 - X2 of instance SUB 1 of the subtractor.

Description: Setting parameter for the run-time group in which instance SUB 1 of the subtractor is to be called.

Value: 5: Run-time group 5

6: Run-time group 6

9999: Do not calculate

Description: Setting parameter for the run sequence of instance SUB 1 within the run-time group set in p20108.

Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run

sequence value.

Description: Sets the signal source of the factors X0, X1, X2, X3 of instance MUL 0 of the multiplier.

Index: [0] = Factor X0

[1] = Factor X1

[2] = Factor X2

[3] = Factor X3

p20106[0...1] CI: SUB 1 inputs / SUB 1 inputs

Access level: 3 Calculated: - Data type: U32 / FloatingPoint32

Can be changed: T Scaling: PERCENT Data set: -